Pinhole Images

1. Put pinhole array in primary focus.
2. Insert the AO focus filter in front of the secondary focus.
3. Turn AO on
4. Turn CT off
5. Check that closed loop = 100% (if not, ask staff)

6. For the red beam:

   Run Mode:	Save all	for all cameras
   Enable:	SOUP	for the SOUP camera
   Repeats:	0
   Frames:	125

7. Wait for about 3 sets of images
8. For the blue beam:

   Run Mode:	Save all	for all cameras
   Enable:	Rotatable Filter	for rotatable filter camera
   Repeats:	0
   Frames:	50

9. Wait for about 2 minutes.

Note that for successful MOMFBD restorations, it is important to take pinhole images at least once a day. This is to make sure that the cameras are still correctly aligned.